• Proper installation procedures must be followed when completing an installation or relocation of a unit. Consult the installation guide before any installation begins. U-Line contact information appears on the rear cover of this guide. • This unit requires connection to a dedicated 15 Amp...
3 Inspect & Plan Product Registration You have received a carton containing your U-Line Combo Drawer Model Ice Maker/Refrigerator or U-Line Refrigerator with a package inside containing a Use and Care Guide, a Product Registration Card, water connection parts and Anti-Tip Kit.
4 Prepare Site Your U-Line product has been designed for either free-standing or built-in installation. When built-in, your unit does not require additional air space for top, sides, or rear. However, the front grille must NOT be obstructed and clearance is required for an electrical connection in the rear.
The drawer unit can be installed with an appliance or fixture located in front of it, as long as there is adequate clearance for the drawer to be opened and removed when servicing. U-Line recommends you consider additional clearance in front of the open drawer for convenience. Other Site Requirements...
This is caused by the front slide mountings not being level with the rear slide mountings. U-Line Drawer Alignment IMPORTANT IMPORTANT Not Aligned Side-to-Side Top View of Unit Loosen...
1. Set the drawer’s rails onto the slides. 2. Re-install the rails’ mounting screws. See Figure 13 on Page 10. 3. Plug in the drawer’s connection wiring (top drawer only). Top View of Unit U-Line Drawer Alignment Mounting Screws Push Slide Upward or...
2. Remove and save the two screws (1) located at the ends of the handle. Remove the handle. Handle Handle Screw Gasket 3. Remove existing panel and cardboard spacer. Discard the spacer. Standard Handle Full Handle U-Line Drawer Panel Installation IMPORTANT IMPORTANT Screw Gasket...
Page 11
Step 2 under Removing Existing Drawer Fronts. 3. Starting at the corners and working toward the center, push the drawer gasket back into place. Go on to 5 Adjust Drawers. 1" U-Line Drawer Panel Installation CAUTION Typical Drawer Panel...
Hook and Loop Fastener Mount You may also mount your overlay to your grille using hook and loop type fasteners. U-Line recommends using 3M® Dual lock® fasteners. To mount your overlay using a hook and loop fastener follow the instructions below.
IMPORTANT IMPORTANT U-Line requires the use of copper tubing, or U-Line water line hook up kit (U-MPWATERHOOKUP) for installation. Do not use any plastic water supply line. The line is under pressure at all times. Plastic may crack or rupture with age and cause water damage to your home.
A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly. Countertop or Wall Header Cabinet or Wall Stud U-Line Electrical / Plumbing Specfications IMPORTANT IMPORTANT CAUTION...
First Time Start Up All U-line units are shipped from the factory with controls that are preset. No initial adjustments are required. Once installation and leveling is complete, the unit is ready for initial start-up and operation. Open the top drawer press and hold the POWER icon on the display panel for aproximately ten seconds until the °F symbol flashes and release.
E-mail: onlineparts@u-line.com ABOUT U-LINE Building on 45 years, U-Line has captivated those with an appreciation for the finer things with exceptional design, inspired innovations and attention to even the smallest details. U-Line is synonymous with premium built-in under counter ice making, refrigeration and wine storage appli- ances, the U-Line Corporation is committed to luxury under the counter.