Door Alignment Check And Adjustment - U-Line WINE CAPTAIN 2275XWCOL Use And Care Manual

Door Alignment Check and
Adjustment
IMPORTANT IMPORTANT
When properly aligned:
• The door will not be flush with the top of the
cabinet. The top edge of the door will be 1/8 in.
(3.175 mm) below the cabinet top.
• The door gasket will be firmly in contact with the
perimeter of the cabinet and not pinched on the
hinge side of the door.
The following procedure will correct for up to 1/4 in.
misalignment:
1/8"
(3.175 mm)
Figure 14. Checking Door Alignment
1. Compare the top edge of the door (opposite the
hinges) to the top edge of the cabinet (Figure 14) and
note the type (up or down) of adjustment needed.
Figure 15. Top Hinge Mounting
2. Remove the top hinge pivot pin with a Phillips
screwdriver (Figure 15) and lift door off bottom hinge
pin. Be careful not to lose the door closer insert sets.
3. Turn the door upside down and inspect the hinge plate
mounting holes.
Your plate has slotted mounting holes (Figure 16).
Loosen but do not remove the two hinge plate screws.
4. If door edge opposite the hinges needs to move up,
move plate toward outside of door. If door edge needs
to move down, move plate toward inside of door
ULIN_0016_A
ULIN_0133_A
2275ZWC & 2275ZWCOL
(Figure 16). Repeat until top edge of door is parallel
with top of cabinet and tighten screws securely.
Slotted Mounting Holes
Toward outside
Figure 16. Door Hinge Plate Mounting Holes -
Wine Captain and Beverage Center Models
Figure 17. Bottom Hinge Door Closers
5. After adjustment is complete, remove the door closers
from the bottom hinge, clean thoroughly and apply
petroleum jelly to the mating surfaces of the closers. Be
sure that bosses on closers (Figure 17) align with holes
in the door and bottom cabinet hinge plates. Mount
door and install top hinge pivot pin.
Toward inside
ULIN_0007_A
Bosses
ULIN_0004_A
11