Door Alignment Check And Adjustment; Grille Installation - U-Line Origins 1075BEVS00 Use And Care Manual

Figure 9
1. Use a level to check the levelness of the unit from front
to back and from side to side. Level should be placed
along top edge and side edge as shown (Figure 9).
Adjustable foot
Figure 10
2. If the unit is not level, adjust the feet on the corners of
the unit as necessary (Figure 10).
3. Check the levelness after each adjustment and repeat
the previous steps until the unit is level.
NOTE: If the room floor is higher than the floor in the cut-
out opening, adjust the rear feet to achieve a total unit
rear height of 1/8" less than the opening's rear height.
Shorten the unit height in the front by adjusting the front
feet. This allows the unit to be gently tipped into the
opening. Readjust the front feet to level the unit after it is
correctly positioned in the opening.
Door Alignment Check and
Adjustment
IMPORTANT IMPORTANT
When properly aligned:
• The door gasket should be firmly in contact with
the cabinet all the way around the door (no gaps).
Carefully examine the door gasket to ensure that
it is firmly in contact with the cabinet.
• The door gasket will be firmly in contact with the
perimeter of the cabinet and not pinched on the
hinge side of the door.
NOTE: It may be necessary to remove the grille to access
lower hinge screws.
ULIN_0042_A
ULIN_1020_A
1075BEV
Figure 11
1. Loosen (do not remove) top (Figure 11) and bottom
hinge screws.
2. Align door squarely with cabinet.
3. Make sure gasket is firmly in contact with cabinet all
the way around the door (no gaps).
4. Tighten bottom hinge screws.
5. Tighten top hinge screws.

Grille Installation

Grille Screw
Figure 12
1. Locate and remove the grille screws from cabinet,
using a standard blade screwdriver (or a 1/4"
nutdriver) (Figure 12).
2. Remove the control knob by pulling it away from the
cabinet.
3. Identify the grille screw hole on the grille itself. It is
located toward the top of the middle recessed section
of the grille.
4. Place the two hook-hinges (located on the rear bottom
side of the grille) onto the front lip of the unit base
(Figure 13). Swing the grille up into position, aligning
the screw hole on the grille to the screw hole on the
cabinet.
5. Insert the screw. Do not overtighten.
6. Reinstall control knob.
Hook-Hinge
Figure 13
Grille
Hook-Hinge
Unit Base
Front Lip
9