Door Switch Assembly And Parts; Monitor Safety Switch Parts - TurboChef NGC-1007 Service Manual

40 THE OVEN DOOR
50
51
52
2 9 : Correct Primary and Secondary Interlock
F I G U R E
Adjustment and Parts - Old Switch Setup

DOOR SWITCH ASSEMBLY AND PARTS

Figure 30, next page
53. NGC-1072
54. 102012
55. NGC-1087
56. NGC-1073
57. 101119
58. 100059
59. 101557
60. 102921
61. NGC-1126
62. NGC-3006
63. 101296
Assembly Notes
1. Ring, e-clip (Item 63) is supplied with Item 56.
2. Spring and bracket must be lubricated with high-
temperature pure FM grease (Item 62).
3. Assembly must be hand-tightened prior to any
final adjustment.
49
-
APPLY HI TEMP
GREASE TO AREA
48
47
TOGGLE SHOULD BE LESS THAN
OR EQUAL TO 85 º DOWN
=
0.020"
SWITCH GAP
Bracket Latch
Switch, Micro, 0.1A/125VAC
Spring Door Latch
Toggle, Latch
Pin, Clevis, ø3/16 x 1" Lg
Bearings, Bronze,
3/16ID x 5/16OD x 1/4" Lg
Screw, #4-40 x 1.25" Lg,
PPHD, CRES
Screw, #8-32 x 3/8", Internal
Tooth Sems, PPHD, SS
Plate, Door Switch
Grease, USDA H-1, Food Grade
Ring, E-clip
ADJUSTING THE MONITOR SWITCH - OLD SETUP
The old switch assembly is identifiable by the moni-
tor switch being located on the right hinge assembly.
Also, the serial number of the oven will follow this
formatting (X = variable digit/letter):
NGC-XXXXX (North America)
NGCXX-XXXXX (International)
To adjust the switch, follow the steps below.
1. Ensure the oven door is adjusted. Refer to
ING THE COOK DOOR
2. Turn on oven and bring it to the set temperature.
: Oven surfaces are HOT! Use
W A R N I N G
extreme caution when making adjustments.
3. Open and close the oven door several times to
ensure the door closes smoothly and the door
actuator (Item 47) clears the slot in the flange.
Reference Figure 29.
4. Disconnect oven from power source.
5. To adjust the monitor safety switch (Figure 31),
loosen the #8-32 screw and the two (2) #4-40
screws (Items 68 and 69) securing the switch.
6. Rotate the monitor safety switch (Item 65) until
the gap between the switch paddle and the switch
body is 0.02" (0.5 mm).
7. Open and close the oven door several times to
make certain the adjustment is correct.
8. Tighten all screws.
9. Reconnect oven to power source.
10. Allow oven to sit at the set temperature for 10
minutes and confirm all adjustments.

MONITOR SAFETY SWITCH PARTS

Figure 31, next page
64. 102804 Hinge, Right
65. 102012 Switch, Limit, Micro
66. NGC-1126 Plate, Door Switch
67. 101912 Standoff, #8-32F/Fx1 in S
68. 102921 Screw, #8-32 x 3/8"
69. 102902 Screw, 4-40 x 5/8"
ADJUST
on page 38.
-