Windscreen Washer Fluid - MARUTI SUZUKI EECO Manual

For regular maintenance, you do not need
to remove the radiator cap.
But, if you need to remove the radiator cap
for some reason, do as follows:
When the engine is cool, remove the radia-
tor cap by turning it slowly to the left until a
"stop" is felt. Do not press down while turn-
ing the cap. Wait until any pressure is
released, then press down on the cap and
continue turning it anticlockwise.
EXAMPLE
09-70G146A
WARNING
It is hazardous to remove the radiator
cap when the water temperature is
high, because scalding fluid and
steam may be blown out under pres-
sure. Wait until the coolant tempera-
ture has lowered before removing the
cap.
Coolant Replacement
if you simply drain and refill the cooling
system, much air will be trapped in the
cooling system and the engine will be
overheated.
EXAMPLE
09-77A044A
The air trapped in the cooling system must
be bleed when filling coolant. Trust this job
to your Maruti Suzuki authorised work-
shop.
CAUTION
Do not drive the vehicle with the air
trapped in the cooling system. If you
do, the engine will overheat and can
be damaged.
INSPECTION AND MAINTENANCE
WINDSCREEN WASHER
FLUID
EXAMPLE
Front (and Rear if equipped)
09-77A072A
Check that there is washer fluid in the tank.
Refill it if necessary. Use a good quality
windscreen washer fluid, diluted with water
as necessary.
WARNING
Do not use "anti-freeze" solution in
the windscreen washer reservoir.
This can severely impair visibility
when sprayed on the windscreen,
and also damage your vehicle's paint.
CAUTION
Damage may result if the washer
motor is operated with no fluid in the
washer tank.
76MH1-74E
8-12