Lighting/Turn Signal Control Lever; Hazard Warning Switch - MARUTI SUZUKI EECO Manual

LIGHTING/TURN SIGNAL
CONTROL LEVER
EXAMPLE
03-76G001A
This control lever is located on the out-
board side of the steering column. Operate
the lever as described below.
Lighting Operation
To turn the lights on or off, twist the knob
on the end of the lever. There are three
positions: in the "OFF" position all lights
are off; in the middle position the front
parking lights, tail-lights, registration plate
light, and instrument lights are on, but the
headlights are off; in the third position the
headlights come on in addition to the other
lights.
EXAMPLE
HIGH
LOW
PASS
03-76G002A
With the headlights on, push the lever for-
ward to switch to the high beams (main
beams) or pull the lever toward you to
switch to the low beams. When the high
beams (main beams) are on, a light on the
instrument panel will come on. To momen-
tarily activative the high beams (main
beams) as a passing signal, pull the lever
slightly towards you and release it when
you have completed the signal.
EXAMPLE
03-76G003A
Turn Signal Operation
With the ignition switch in the "ON" posi-
tion, move the lever up or down to activate
the right left turn signals.
EXAMPLE
03-76G004A
STEERING COLUMN CONTROLS
Normal Turn Signal
Move the lever all the way up to signal a
left turn or all the way down to signal a
right turn for right hand drive. When the
turn is completed, the signal will cancel
and the lever will return to its normal posi-
tion.
Lane Change Singnal
Some times, such as when changing
lanes, the steering wheel is not turned far
enough to cancel the turn signal. For con-
venience, you can flash the turn signal by
moving the lever part way and holding it
there. The lever will return to its normal
position when you release it.

HAZARD WARNING SWITCH

EXAMPLE
03-76A047A
76MH1-74E
2-2