High Mount Stop Lamp - MARUTI SUZUKI EECO Manual

EXAMPLE
(1)
05-77A055A
WARNING
The jack should be used only to
change wheels. It is important to read
the jacking instructions in the "Emer-
gency service" section of this manual
before attempting to use the jack.
WARNING
After using the jack, jack handle be
sure to stow them securely or they
can cause injury if an accident
occurs.
EXAMPLE
05-77A067A
The spare tyre is stowed under the rear
floor.
To remove the spare tyre:
1) Loosen the spare tyre holder hook bolt
(1).
2) Unhook the spare tyre holder and lower
it slowly.
3) Remove the tyre.
NOTICE
Make sure that the spare tire is fixed
securely. Loosely fixed tire may
cause noise during driving.
OTHER CONTROLS AND EQUIPMENT

HIGH MOUNT STOP LAMP

EXAMPLE
High mount stop lamp is provided on back
door. The stop lamp will glow when the
brake pedal will be depressed.
To change the bulb of the stop lamp,
remove the clips at both sides of the cover,
by pressing the inner pin inside so that the
clip gets loose and remove the bulb on
turning it anticlockwise
The rating of each bulb is 5W/12V.There
are five bulbs in high mount stop lamp.
78MM04002
4-8
76MH1-74E