Tunturi C20 Owner's Manual page 4

ARMS
Push the metal shaft through the bracket housing
of the left arm. Attach now the left arm to the
front frame tube by pushing the metal shaft
through the opening in the tube. Push the right
arm on the shaft and lock it by tightening a large
washer, a locking sleeve and a screw to the both
ends of the shaft. Tighten the arms using two Allen
keys.
Push the left footrest support forward so that you
can push the tube in the front of the foot rest
support inside the arm tube. Lock the tube with
the locking screw. Repeat the procedure with the
right footrest support.
HANDLEBAR
Attach the handle bar into the front frame tube
with four washers and two bolts. Thread the hand
pulse cords through the opening in the front frame
tube towards the console. Pull the screws tightly
so that the handlebar does not move during the
training. Be careful not to damage the cords!
4
CONSOLE
Attach the hand pulse cords to the console outlets.
Attach the main cord to the connector behind the
console. Attach the console onto the end of the
front tube and faste with four fastening screws.
TRANSFORMER
Before connecting the equipment to a power
source, make sure that local voltage matches that
indicated on the type plate: the equipment operates
at either 230 V or 115 V (North American
version). NOTE! The equipment must be
connected to a grounded wall socket. Do not use
extension wires when connecting the equipment to
the power source. Make sure the power cord does
not run underneath the equipment.
Insert the small connector into the receptacle on
the unit housing. Then connect the transformer to
the power outlet. The unit is now ready to use.
Do not use your home exercise unit if there is any
sort of damage to the power cord or to the unit.
Keep the power cord away from hot objects.
Do not use your exercise unit out of doors or in
damp locations.