Symptom
CIRCUIT
BREAKER
TRIPS
drawing treadmill
obstruction
Support Services 800-883-8783
Probable Cause
Possible short in
treadmill wiring.
Motor issues.
Incline motor
down
Bad PWM
Too much tension
on belt or
under
belt.
Weakened circuit
breaker or High
belt/deck friction
Mon-Fri 8:30am-5:00pm Central Time Zone
Corrective Action
•
Power off the treadmill and inspect all
wiring for shorts or burned areas.
•
Secure all connectors.
--------
•
Disconnect motor leads from the PWM.
Power on treadmill, press start. If the
breaker does not trip check the motor
brushes and perform the motor test
procedure (page 22).
•
Reconnect motor to the PWM, if the
breaker trips- replace the motor.
--------
•
Unplug incline motor.
•
Power on treadmill, if breaker does not
trip- replace incline motor.
--------
•
Unplug PWM, power on machine. If
breaker doesn't trip- replace PWM.
--------
•
Check for correct tension adjustment
(page 22)
•
Check for obstruction- remove
obstruction.
--------
•
Perform AC Amp Draw Test (page 20)
at circuit breaker.
•
If draw is less than 15 amps
continuously - replace breaker.
•
Perform Amp Draw test (page 20) If
Amp draw is higher than recommended
try push test (page 24) procedure.
Recommended Tools
Allen Key set
Needle nose pliers
Socket set
Multi-meter
Note:
All trouble
shooting should
be performed in
calibration
mode.
Page 16
Fax: 636-272-7148
Page 13