Symptom
SPEED
FLUCTUATION
No Belt Movement
S4: Sensor
E5: Speed Sensor
E2: Overspeed
E3: EPROM Error
E3: EPROM Error
Support Services 800-883-8783
Probable Cause
No/Intermittent
Tach Feedback
Overspeed Error
Software error
during treadmill
startup
Mon-Fri 8:30am-5:00pm Central Time Zone
Corrective Action
•
Go to page 5, 6.
--------
•
Enter Calibration mode (page 16)
•
Verify speed feedback in speed display
through out the speed range. [Speed
display should never show 0 mph when
belt is moving]
•
If no tach feedback is available perform
speed sensor test (page 21).
•
Check continuity of tach feedback
portion of the data cable (To identify
tach feed back lines see wiring diagram
section for specific model).
--------
•
Check/Adjust tread belt tension (page
22)
•
Perform speed sensor test (page 21) If
speed sensor fails adjust gap, if still
fails-replace speed sensor.
•
Perform belt / deck wear test (page 24)
If badly worn, replace belt and deck.
•
Replace PWM
--------
•
Restart unit- if error persists, replace
control panel.
Recommended Tools
Multi-meter
Socket Set
Silicone Lubrication
Packet
Silicone Lubrication
Applicator
Note:
All trouble
shooting should
be performed in
calibration
mode.
Page 16
Fax: 636-272-7148
Page 11