Service - Troy-Bilt Squall 2100 Operator's Manual

Service

Replacing Belt
1. Remove the belt cover by removing the five hex screws
that secure it to the frame. See Fig. 7-1.
Belt Keeper
2. Remove the belt by grasping it from the bottom of the
auger pulley and pulling outward.
NOTE: Push down on the idler puller to release the belt
from under the belt keeper. See Fig. 7-1.
18
Idler Pulley
Hex Screws
Figure 7-1
To replace the belt follow these instructions and refer to Fig. 7-2:
Auger Pulley
2
4
Figure 7-2
1. Push down on the idler pulley.
2. Position the belt on top of the auger pulley and under the belt
keeper.
3. Route the belt around the engine pulley.
4. Push the belt over the bottom of the auger pulley.
5. Reinstall the belt cover removed earlier.
8
1
3
Engine Pulley