Day Mode - User Option - Honeywell NOTIFIER ID61 Operating Manual

5
[U0 Disable/Enable]
3
Start Day Mode
Press
FIRE
DISABLEMENT
TEST
DELAYS ACTIVE
FIRE OUTPUT: FAULT / DISABLED
FIRE OUTPUT ACTIVE
PLANT ALARM
POWER
997-458-000-8, Issue 8
January 2010
ID61/62 Series Panel - Operating Manual
[U0 Disable/Enable]

4.10.3 Day Mode - User Option

If Day Mode is enabled during panel commissioning, this
option allows the user to activate/deactivate Day Mode
delays during the set Day Mode time period. This has no
effect on any sensor sensitivity changes that may have
been configured during commissioning. Any sensor
sensitivity changes will automatically occur at the set Day
Mode period start and end times.
To Disable/Enable Day Mode, proceed as follows:
1:Zone
3:Day Mode 4:Delays
1 From the Disable / Enable menu, press the '
to confirm
2 Press the '
5
[U0 Disable/Enable] 1:Zone
3:Day Mode
3 To end Day Mode, repeat steps 1 and 2 (the display is
End Day Mode
Press
Note: If Day Mode is NOT cancelled manually, Day Mode
32
1:Zone
3:Day Mode 4:Delays
The FIRE CONTROL O/P: FAULT/DISABLED, FIRE
OUTPUT: FAULT/DISABLED and the SOUNDERS
DISABLED LEDs extinguish when the corresponding
outputs have been enabled. The DISABLEMENT LED
will only extinguish when ALL disablements have been
enabled.
2:Outputs
to display the following:
<:Cancel
' button to confirm the requested
5
operation. The LCD automatically returns to the
Disable/Enable menu.
If Delays have been configured the DELAY ACTIVE
LED illuminates when Day Mode is started.
2:Outputs
4:Delays
as shown below):
to confirm
The DELAY ACTIVE LED will extinguish when the Day
Mode operation has been ended, either when day
mode is turned off or when the timer has timed out.
No delays are active.
delays are automatically deactivated at the end of
the set time period.
2:Outputs
' button
3
<:Cancel