Configuration - Tripp Lite APSINT612 Owner's Manual

Dc-to-ac inverter/charger

Table of Contents

Configuration

Set Configuration DIP Switches

Using a small tool, set the Configuration DIP Switches (located on the front panel of your unit, see diagram) to optimize Inverter/Charger

operation depending on your application.

DIP Switches

Select Battery Type—REQUIRED

CAUTION: The Battery Type DIP Switch setting must match

the type of batteries you connect, or your batteries may be

degraded or damaged over an extended period of time. See

"Battery Selection," p. 7 for more information.

Battery Type

Gel Cell (Sealed) Battery

Wet Cell (Vented) Battery

Select Low AC Input Voltage Point for Switching to

Battery—OPTIONAL*

Voltage

201V

182V

163V

144V

* Most of your connected appliances and equipment will perform adequately when your Inverter/Charger's High AC Input Voltage Point is left in the factory setting and its Low AC Voltage Input

Point is set to 182V. However, if the unit frequently switches to battery power due to momentary high/low line voltage swings that would have little effect on equipment operation, you may wish to

adjust these settings. By increasing the High AC Voltage Point and/or decreasing the Low AC Voltage Point, you will reduce the number of times your unit switches to battery due to voltage swings.

Connect Remote Control—Optional

All models feature an 8-conductor telephone style receptacle on the front panel for use with an optional remote control module (Tripp Lite

model APSRM2, sold separately). The remote module allows the Inverter/Charger to be mounted in a compartment or cabinet out of sight, while

operated conveniently from a remote location. See instructions packed with the remote control module.

Switch Position

Down (factory setting)

Switch Position

#A4 Up & #A3 Up

#A4 Up & #A3 Down

#A4 Down & #A3 Up

#A4 Down & #A3 Down (factory setting)

INPUT C/B 10A