Exmark TURF RANGER TR23KC Operator's Manual page 34

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
6.2.13 Steering Chain Adjustment
6.2.14 Throttle Control Adjustment
6.2.15 Throttle Cable Tension
6.2.16
( c )
ELECTRIC CLUTCH ADJUSTMENT
a) Position the steering handle bar so that it points the unit straight forward (the
rear steering wheel should be in line with the rider main frame channel).
b) Check to see if the chains are loose.
c) To take up slack in the chains, loosen the rear jam nuts connecting the
eyebolts to cross link bars, then equally tighten each forward jam nut until
slack is taken up. Retighten the forward jam nuts onto the links.
d) If the unit tends to turn left when handle bar is positioned for straight
forward travel, adjust by shortening the right hand link (threading jam nuts
closer to "eye" end of the eyebolt) and lengthening the left hand link
(threading jam nuts away from the "eye" end of the eyebolt) an equal
amount. Re check chain tension.
e) If the unit tends to turn right when handle bar is positioned for straight
forward travel, reverse procedure as stated in paragraph "d" above.
Loosen the cable clamp on the engine and position the throttle control at the
control console within 1/8" from the upper end of the slot. Pull on cable
assembly at lower end, where it attached to the engine, until the throttle control
arm contacts the stop screw. Secure cable with cable clamp.
Tension in throttle lever can be adjusted by adjusting the tightness of the lever
pivot bolt, which is located under the console.
Seat armrest adjustment.
a) Lift armrest on seat. Locate square tab marked with the numbers 1 through
4. Rotate square tab 1/4 turn to raise or lower the armrest in approximately
1/4" increments. See Fig. 13.
ARMREST ADJUSTMENT
www.mymowerparts.com
FIG. 12
FIG. 13
- 29 -