Exmark TURF RANGER TR23KC Operator's Manual page 26

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
6.1.9 Check hydraulic oil level:
6.1.10 Check tire pressures:
6.1.11 Check battery charge:
e) Remove the oil drain plug from the rear of the engine. Allow oil to drain then
replace drain plug.
f) Lower cutter deck so that engine deck is level.
g) Replace the oil filter as per Engine Owner's Manual. Clean around oil filter
and unscrew filter to remove. Before reinstalling new filter, apply a thin
coating of oil on the surface of the rubber seal. Turn filter clockwise until
rubber seal contacts the filter adapter then tighten filter an additional 2/3 to
3/4 turn.
h) Clean around oil fill cap and remove cap. Fill to specified capacity and
replace cap. Use oil as directed in Engine Owner's Manual. Do Not overfill.
i) Start the engine and check for leaks. Stop engine and recheck oil level.
Service Interval: 40 hrs.
a) Make sure mower is on a level surface.
b) Stop engine and remove ignition key.
c) Visually inspect the sight gauge on hydraulic tank. Oil level should be
visible to top of sight gauge. If not, clean area around hydraulic reservoir
cap, remove cap, and add oil as specified in Section 2.7 (Specifications).
Replace cap.
POTENTIAL HAZARD
♦ Hydraulic fluid escaping under pressure can penetrate
skin and cause injury.
WHAT CAN HAPPEN
♦ Fluid accidentally injected into the skin must be
surgically removed within a few hours by a doctor
familiar with this form of injury or gangrene may result.
HOW TO AVOID THE HAZARD
♦ Make sure all hydraulic fluid hoses and lines are in
good condition an all hydraulic connections and fittings
are tight before applying pressure to hydraulic system.
♦ Keep body and hands away from pinhole leaks or
nozzles that eject high pressure hydraulic fluid.
♦ Use cardboard or paper to find hydraulic leaks.
♦ Safely relieve all pressure in the hydraulic system
before performing any work on the hydraulic system.
Service Interval: 40 hrs.
a) Stop engine and remove ignition key.
b) Inflate tires to pressures specified in Section 2.8 (Specifications).
c) See Section 7.1 for further information.
Service Interval: Monthly
a) Check the voltage of the battery with a digital voltmeter. Locate the voltage
reading of the battery in the table below and charge the battery for the
recommended time interval to bring the charge up to a full charge of 12.6
volts or greater.
www.mymowerparts.com
WARNING
- 21 -