Exmark TURF RANGER TR23KC Operator's Manual page 25

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
6.1.6 Check for loose hardware:
6.1.7 Service pre-cleaner element and air cleaner:
6.1.8 Change engine oil:
b) Check operator presence control (OPC) circuits: Run engine at one-third
throttle with blade clutch and parking brake disengaged; lift yourself off the
seat (but do not get off the machine) engine must stop after 1/2 second has
elapsed.
c) Run engine at one-third throttle with blade clutch and parking brake
engaged; lift yourself off the seat (but do not get off the machine) engine
must stop after 1/2 second has elapsed.
d) If machine does not pass any of these tests, Do Not operate. Contact your
authorized EXMARK Servicing Dealer or Distributor.
IMPORTANT: It is essential that all Operator Safety Mechanism be connected
and in proper working condition prior to use for mowing.
Service Interval: Daily
a) Stop engine and remove ignition key.
b) Visually inspect machine for any loose hardware or any other possible
problem. Tighten hardware or correct the problem before operating.
Service Interval: 25 hours
More often under Severe Conditions.
a) Stop engine and remove key.
b) Loosen wing nut and remove air cleaner compartment cover.
c) Remove foam pre-cleaner element and wash in warm water with detergent.
Rinse until all traces of detergent are eliminated and squeeze out excess
water (DO NOT wring). Air dry. Saturate with engine oil and squeeze out
excess oil.
d) Check paper element. Gently tap the flat side of the paper element to
dislodge any dirt. DO NOT wash or use pressurized air to clean paper
element. Replace if dirty, bent or damaged.
e) Reinstall foam pre-cleaner to paper element
POTENTIAL HAZARD
♦ The engine can become very hot.
WHAT CAN HAPPEN
♦ Touching a hot engine can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the engine to cool completely before service or
making repairs around the engine area.
Service Interval: See Engine Owner's Manual
NOTE: Change oil after first five (5) hours of operation, then refer to engine
manual for future oil change frequencies.
a) Disengage electric blade clutch.
b) Raise cutter deck to tilt the engine for draining.
c) Stop engine and remove ignition key.
d) Drain oil while engine is warm from operation.
www.mymowerparts.com
WARNING
- 20 -