Exmark TURF RANGER TR23KC Operator's Manual page 19

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.7.6 Install cutter deck stationary idler. Locate two holes along the back center
3.7.7 Install cutter deck drive belt.
3.7.8 Adjust cutting height of deck and anti-scalp rollers. See Section 6.2.1.
3.8 Service engine: See Engine Operator's Manual.
POTENTIAL HAZARD
♦ Removing the two blocks prior to installing the cutter
deck and support for counter balance will allow the
engine deck to flip backwards.
WHAT CAN HAPPEN
♦ If the engine flips backwards pinch points are created,
which may cause injury.
HOW TO AVOID THE HAZARD
♦ Keep hands clear from the engine deck when
removing the blocks.
section of the cutting deck. Install the stationary idler and related parts in the left
hand hole location as shown in Figure 2. See the belt routing decal on deck. Be
sure the coned end of the disc spring is against the head of the bolt as illustrated
(see Figure 2).
NOTE: Make sure to use proper belt for your deck. The belt (Part #543523) that
is installed on the unit is for 60"decks only. For 52" decks, the belt (Part
#543749) from the bolt bag must be used. Refer to belt routing decal on deck.
Slip belt between clutch drive sheave and drive wheel release rod (make sure
belt is in the sheave groove).
Place the other end of the belt over cutter deck drive sheave and rotate this
sheave until the belt slips into sheave groove. Pull tensioning idler assembly
back to allow belt to engage tensioning idler sheave and stationary idler sheave.
Check fixed idler sheave on engine deck to make sure the belt also travels in the
idler sheave groove.
Install the center cutter deck belt shield.
IDLER PULLEY KIT AND LOCATION
(Adjustments).
www.mymowerparts.com
CAUTION
FIG 2
- 14 -