Lincoln Electric V160-S Service Manual page 28

E-6
INSULATED GATE BIPOLAR TRAN-
SISTOR (IGBT) OPERATION
An IGBT is a type of transistor. IGBT are semiconduc-
tors well suited for high frequency switching and high
current applications.
Example A in figure E.6 shows an IGBT in passive
mode. There is no gate signal, zero volts relative to the
source, and therefore, no current flow. The drain ter-
minal of the IGBT may be connected to a voltage sup-
ply; but since there is no conduction, the circuit will not
supply current to the components connected to the
source. The circuit is turned OFF like a light switch.
n +
p
n -
n +
p +
DRAIN
A. PASSIVE
THEORY OF OPERATION
F F I I G G U U R R E E E E . . 6 6 - - I I G G B B T T
GATE
SOURCE
n +
BODY REGION
DRAIN DRIFT REGION
BUFFER LAYER
INJECTING LAYER
V160-S & -T
Example B shows the IGBT in an active mode. When
the gate signal, a positive DC voltage relative to the
source, is applied to the gate terminal of the IGBT, it is
capable of conducting current. A voltage supply con-
nected to the drain terminal will allow the IGBT to con-
duct and supply current to the circuit components
coupled to the source. Current will flow through the
conducting IGBT to downstream components as long
as the positive gate signal is present. This is similar to
turning ON a light switch.
SOURCE
n +
p
n -
n +
p +
DRAIN
B. ACTIVE
E-6
POSITIVE
VOLTAGE
APPLIED
GATE
n +
BODY REGION
DRAIN DRIFT REGION
BUFFER LAYER
INJECTING LAYER