Interface Module Leds - Cisco ASR 907 Hardware Installation Manual

Troubleshooting
PWR LED
State
Flashing
Light
Green and
Green
alternatively
Green

Interface Module LEDs

The LED summary applies to the following interface modules:
• SFP Gigabit Ethernet Interface Module
• RJ45 Gigabit Ethernet Interface Module
• XFP 10 Gigabit Ethernet XFP Interface Module
• 8x1 Gigabit Ethernet SFP + 1x10 Gigabit Ethernet SFP+ Interface Module
• 8x1 Gigabit Ethernet RJ45 + 1x10 Gigabit Ethernet SFP+ Interface Module
• 2x10 Gigabit Ethernet SFP+ Interface Module
• 48 T1/E1 TDM Interface Module (48XT1/E1)
• 48 T3/E3 TDM Interface Module (48XT3/E3)
• 1-port OC-192 or 8-port Low Rate CEM Interface Module
• 8/16-port 1 Gigabit Ethernet (SFP/SFP) + 1-port 10 Gigabit Ethernet (SFP+) / 2-port 1 Gigabit Ethernet
The Status LED is Amber for the 10 Gigabit Ethernet ports when operating in WAN mode for the following
IMS:
• 8x1 Gigabit Ethernet SFP + 1x10 Gigabit Ethernet SFP+ Interface Module
• 8x1 Gigabit Ethernet RJ45 + 1x10 Gigabit Ethernet SFP+ Interface Module
• 2x10 Gigabit Ethernet SFP+ Interface Module
STAT LED Indication
State
Off FPGA configured and core validated
successfully.
FPGA image passed the control to
micro-loader to boot ROMMON.
Amber The digital code signing functionality
reported upgrade FPGA image
validation error and is continuing with
the FPGA image.
Red The digital code signing functionality
reported failure in the ROMMON
image validation.
Off IOS is successfully booted
(CSFP) Interface Module
Comment
System is up with ROMMON. Both the
FPGA image is validated successfully, but
the booted ROMMON (primary or
secondary) is undetermined.
System is up with ROMMON. FPGA
image is validated successfully, but the
booted ROMMON (primary or secondary)
is undetermined.
FPGA is up but both primary and
secondary ROMMON failed. System is in
hung state.
IOS writes into FPGA register to indicate
that it has booted, FPGA stops flashing
PWR LED and turns Green. Software now
controls the STAT LED.
Cisco ASR 907 Router Hardware Installation Guide
Interface Module LEDs
183