Address Setting Mode Via The C.i.e; Flow Chart - Panasonic External Presentation unit 1728 Technical Description

Hide thumbs Also See for External Presentation unit 1728:

Table of Contents

Panasonic Electric Works Nordic AB

MEW01297 Rev: 2

6.2.1

6.3

Technical Description External Presentation Unit 1728, ver. 1.4.x

For an ext. Presentation unit with SW mode 1728 - 1587, the address

can be set to 00-15.

For an ext. Presentation unit with SW mode 1728 - 1582, the address

can be set to 01-08. (Default is "01".)

Scroll to the wanted address with the push button "P1" (black).

Store the selected address with the push button "P2" (yellow) and the

unit will automatically restart and enter its normal operation mode.

Address setting mode via the c.i.e.

One specific ext. Presentation unit or all the ext. Presentation units

connected to the same line (RS485) can, in normal operation, from the

c.i.e. receive a command and get ready for the "Address setting"

directly. This is done via menu H5/A9 (A7 in system EBL512 G3),

see Operating instructions for the system respectively.

On the following page is a flow chart, showing the SW mode setting,

Language setting, Address setting, etc.

Normally should not more than eight units be connected to one Ext. FBP /

DU interface board 1587, if not ext. power supply is used.

If the unit has no SW mode, i.e. "Not selected", it will not enter its normal

operation mode after the restart but start from the beginning again, ready for

the SW mode setting.

(Default is "00".)

Table of Contents