Panasonic External Presentation unit 1728 Technical Description page 13

Panasonic Electric Works Nordic AB
MEW01297 Rev: 2
Push button
Alarms queued
P1
(Flera larm)
Silence buzzer
P2
(Summer tyst)
Component
6
Buzzer
Display
Technical Description External Presentation Unit 1728, ver. 1.4.x
Table of push buttons:
Colour Operation / function
Used, when LED "L2" (Alarms queued) is turned on,
Black
to scroll through the queued alarms. (The first alarm
will automatically be shown again after 20 seconds,
if no button is used during that time.)
Used to silence the buzzer in the Ext. Presentation
Yellow
unit. The buzzer will re-sound for an alarm from
another zone.
NOTE! Regarding "P1" and "P2", see also chapter "SW mode &
Address setting, page 12. See also chapter "S/W version", page 25.
Table of others:
Indicating
Intermittent
2
Continuously
Cont. + All LEDs
turned off as well.
Pre-warning, co-incidence
alarm presentation like in the c.i.e. the Ext. Presentation unit is
connected to including a user definable text message (alarm
text), if programmed.
Fault(s) in the system (not corrected / serviced and not
acknowledged) will be presented as "General fault in system".
(NOTE! A fault message may be shown, indicating a
communication fault (i.e. no connection between the unit and
the c.i.e. All LEDs are turned off as well.).
Disablement(s) in the system will be presented as "General
disablement in system".
NOTE! Regarding the Display, see also chapter "SW mode &
Address setting, page 12.
5
When point alarm presentation is valid (set via Win512) the buzzer will re-
sound for an alarm from another alarm point.
6
The buzzer may be programmed as "disabled" (via Win128 / Win512 /
WinG3), i.e. it will never sound.
5
Fire alarm, pre-warning and co-incidence
like in the c.i.e.
Not acknowledged fault in the system or a
fault in the unit.
There is a CPU / memory fault in the unit.
3
, Fire alarm and Heavy smoke / heat
2
11
3
,