Remove The Solid-State Drive Module - Lenovo IdeaPad 5 Hardware Maintenance Manual

Screw specifications
M2 x L3
Go to https://support.lenovo.com/partslookup
replacement part:
Battery pack

Remove the solid-state drive module

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and then remove the solid-state drive module by pulling it away from the slot.
Figure 8. Remove the solid-state drive module
Screw specifications
M2 x L3
Step 3. Remove one screw and then separate the solid-state drive and the sollid-state drive bracket.
Figure 9. Separate the solid-state drive and the solid-state drive bracket
Screw specifications
M2 x L2
32
Hardware Maintenance Manual
Number of screws
2
to look up the Lenovo part numbers of the following
Number of screws
1
Number of screws
1