Remove The Lcd Module - Lenovo IdeaPad 5 Hardware Maintenance Manual

Remove the LCD module

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 46
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Step 2. Disconnect the antennas cable and LCD cable from the system board. Release the antennas cable
from the cable guide.
Figure 50. Disconnect the cables
Step 3. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove four screws.
Figure 51. Rotate the LCD module and remove four screws
Screw specifications
M2.5 x L5
Step 4. Remove the LCD module.
Number of screws
4
.
Chapter 4 Removing a FRU or CRU
55