Installing A Transceiver In The Ptx1000 - Juniper PTX1000 Hardware Manual

4. Using your fingers, pull the ejector lever away from the transceiver to unlock the transceiver.
CAUTION:
completely until you hear it click. Doing this prevents damage to the transceiver.
5. Grasp the transceiver ejector lever and gently slide the transceiver approximately 0.5 in. (1.3 cm) straight
out of the port.
CAUTION:
not touch the connector pins at the end of the transceiver.
6. Using your fingers, grasp the body of the transceiver and pull it straight out of the port (see
Figure 42 on page 106).
7. Place the transceiver in the antistatic bag or on the antistatic mat placed on a flat, stable surface.
8. Place the dust cover over the empty port.
Figure 42: Removing a Transceiver from the PTX1000

Installing a Transceiver in the PTX1000

The transceivers for the PTX1000 are hot-removable and hot-insertable field-replaceable units (FRUs)—you
can remove and replace them without powering off the PTX1000 or disrupting routing functions.
Before removing the transceiver, make sure you open the ejector lever
To avoid electrostatic discharge (ESD) damage to the transceiver, do
106