Cable & Connector (Option); Accessories (Option) - Contec PIO-64/64L(PCI)H User Manual

1. Before Using the Product
Cable & Connector (Option)
Shielded Cable With Two 100pin Connector
Connection Conversion Shield Cable (100P→96P)
Flat Cable with One 100-Pin Connector
Connection Conversion Shield Cable (100pin→37pin D-SUB x 2)

Accessories (Option)

Screw Terminal Unit (M3 x 100P)
Screw Terminal Unit (M3 x 96P)
Screw Terminal Unit (M3.5 x 96P)
Terminal Unit for Cables (M2.5 x 96P)
Connector Conversion Board (96-Pin → 37-Pin x 2)
Signal Monitor for Digital I/O(64Bits)
Screw Terminal Unit (M3 x 37P)
Screw Terminal Unit (M3.5 x 37P)
General Purpose Terminal (M3 x 37P)
Screw Terminal (M2.6 x 37P)
*1 PCB100PS optional cable is required separately.
*2 PCB100/96PS optional cable is required separately.
*3 PCB100WS optional cable is required separately.
*4 If using both the CNA and CNB connectors, two each of the terminal block and cable sets are
required.
*5 If using both the CNA and CNB connectors, two cable sets are required.
You will also require sufficient terminal blocks for the number of I/O points you are using.
*6 "Spring-up" type terminal is used to prevent terminal screws from falling off.
* Check the CONTEC's Web site for more information on these options.
4
: PCB100PS-0.5 (0.5m)
: PCB100PS-1.5 (1.5m)
: PCB100PS-3 (3m)
: PCB100PS-5 (5m)
: PCB100/96PS-1.5 (1.5m)
: PCB100/96PS-3 (3m)
: PCB100/96PS-5 (5m)
: PCA100P-1.5(1.5m)
: PCA100P-3(3m)
: PCA100P-5(5m)
: PCB100WS-1.5(1.5m)
: PCB100WS-3(3m)
: PCB100WS-5(5m)
: EPD-100A *1*4*6
: EPD-96A *2*4*6
: EPD-96 *2*4
: DTP-64A *2*4
: CCB-96 *2*4
: CM-64L *2*4
: EPD-37A *3*5*6
: EPD-37 *3*5
: DTP-3A *3*5
: DTP-4C *3*5
PIO-64/64L(PCI)H, PI-128L(PCI)H, PO-128L(PCI)H