DURKOPP ADLER 911-210 Additional Instructions page 10

Fig. 2: Presettings outside of the machine (2)
(5) - Pin
(6) - Cylinder
6. Extend cylinder (6).
7. Retract cylinder (4).
8. Press the pin (5) against the threaded pin (7).
9. Turn the threaded pin (7).
 Measurement B must be 2.8 mm when the pin (5) abuts on
Fig. 3: Presettings outside of the machine (3)
(5) - Pin
(6) - Cylinder
10. Retract cylinder (6).
11. Loosen the screw (8).
12. Shift the plate (9).
 Measurement C must be 1.3 mm when the pin (5) abuts on the
13. Tighten the screw (8).
14. Place the clamping spring (1).
8
the threaded pin (7).
⑤
⑦
plate (9).
Assembling the neat seam beginning (NSB)
⑤ ⑥
(7) - Threaded pin
(8) - Screw
(9) - Plate
Additional Instructions 911 - 00.0 - 05/2020
⑦
⑨
⑧