Table of Contents
Advertisement
Installation
Oven Assembly
CONVEYOR
1. Slide the conveyor assembly through the left
hand tunnel opening until the sprocket is in-
side the control box. See Figure 6.
2. Install the drive belt on the motor and then
around the pulley on the conveyor assembly.
See Figure 7. Pull the conveyor assembly
back to tighten the belt.
Figure 6
Figure 7
Unless specified otherwise, conveyor travel is fac-
tory set for left to right operation when facing the
front of the oven. To reverse the direction of the
drive motor (if necessary), exchange A1 and A2.
WARNING!!
Disconnect the power supply before re-
versing the drive motor.
CRUMB PANS
1. Install the crumb pans on both ends of the
conveyor.
8
Figure 8
Hide quick links:
Advertisement
Table of Contents
