Replacing The System Board Bracket - Lenovo V130–20IGM AIO User Manual And Hardware Maintenance Manual

Replacing the system board bracket

Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the computer cover is against the surface and the screen is facing up.
3. Remove the tilt-only monitor stand base. See "Replacing the tilt-only monitor stand base" on page 17.
4. Remove the front cover. See "Removing the front cover" on page 17.
5. Remove the tilt-only monitor stand. See "Replacing the tilt-only monitor stand" on page 19.
6. Remove the system board shield. See "Replacing the system board shield" on page 27.
7. Remove the M.2 storage drive. See "Replacing the M.2 storage drive" on page 32.
8. Remove the memory module. See "Replacing the memory module" on page 34.
9. Remove the Wi-Fi card. See "Replacing the Wi-Fi card" on page 35.
10. Remove the system board and heat sink. See "Replacing the system board and heat sink" on page 39.
11. Replace the system board bracket.
Figure 68. Removing the system board bracket
Figure 69. Installing the system board bracket
42
V130–20IGM AIO User Guide and Hardware Maintenance Manual