Wireless Remote Controller; Attachment Of Wireless Kit; Installation Of The Receiver; Local Setup - Mitsubishi Heavy Industries FDCA Series Technical Manual

(4) Wireless remote controller

(5) Attachment of wireless kit

(a)

Installation of the receiver

1) Preparation before installation
1 Attach the cover panel supplied as an accessory onto the indoor unit according to the panel installation manual.
(Refer to 87 pages)
2 Remove the air inlet grille. (Refer to 88 pages)
3 Remove a corner panel located on the refrigerant pipe side. (Refer to 88 pages)
4 Remove three screws and detach the cover (indicated as a shadowed area) from the indoor unit control box.

2) Local setup

1 Remove the cover by unscrewing two screws from the back of the receiver.
LCD display
AUTO COOL DRY FAN HEAT
FAN HI LO
ON AM OFF
PM
MODE TEMP
Operation part
(Inside of lid)
60
4
3
Refrigerant pipes
Screws
FILTER
° C
AM
PM
ON/OFF
20.5
Drain pipe
Cover
1
Wireless kit backside
158
- -
unit: mm
Drain plug