Simple Wired Remote Controller (Rch-E3) - Mitsubishi Heavy Industries FDTC71VNXPVD Data Book

11.2 Simple wired remote controller (RCH-E3)

Notes:
Following functions of Type -D indoor unit series are not able to be set with this simple wired remote controller (RCH-E3).
1. Individual flap control system (for FDT/FDTC)
2. Flap control system (for FDEN)
3. 4-fan speed setting (PHi/Hi/Me/Lo)
Names and functions of sections
Operation/Inspection lamp
During operation: Green
failure: Red
MODE button
Use to select the mode.
TEMP button
Use to raise the setting temperature.
TEMP button
Use to lower the setting temperature.
Operation mode display
: Cooling
: Drying
: Fan operation
: Heating
: Auto mode
Central control display
Displayed when controlling the
unit with the central controller.
Control disable display
The lamp is lit for 3 seconds
when a disabled button is
pressed.
Installation of remote controller
DO NOT install the remote controller at the following places in order to avoid malfunction.
(1) Places exposed to direct sunlight
(2) Places near heat devices
(3) High humidity places
3-fan speed setting (Hi/Me/Lo) (for FDT/FDTC/FDUM/FDEN)
Indoor unit No. display
(4) Hot surface or cold surface enough to generate condensation
(5) Places exposed to oil mist or steam directly
(6) Uneven surface
206
-
Remote controller sensor
Button to start/stop the air conditioner
Button to set the fan speed
Indicates the No. of air conditioner
which is connected.
VRF series outdoor unit No. display
-
'10 • PAC-DB-136
ON/OFF button
FAN SPEED button
AIR CON No. button
Fan speed display
Ventilation display
This is lit during the ventilation
operation.
Setting TEMP display
Error code display
PJZ000Z272
Rem
Wiring o
(In case of embe
12×7 Sl
In ca
0.3mm
L
Wirin
(1)
(2)
a