Introduction; Rating Plate; Installation - Tricity Bendix SB200/3 Operating And Installation Instructions

Splashback electric cooker
Table of Contents

Advertisement

INTRODUCTION

WARNING: THIS APPLIANCE MUST BE EARTHED

RATING PLATE

This is situated on the lower front frame of the
appliance and can be seen upon opening the door.
Alternatively the rating plate may also be found on
the back or top of some models (where applicable).
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance is
given on the rating plate.
Do not remove the rating plate from the appliance
as this may invalidate the guarantee.

INSTALLATION

If your appliance has been damaged in transit,
contact your supplier immediately. DO NOT attempt
to install it.
Your appliance left the factory fully packaged to
protect it from damage.
packaging
and
damage
manufacturer cannot accept responsibility. Contact
your supplier for advice.
Once the packaging has been removed the appliance
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the appliance as
damage may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles. The cable
must have conductors of sufficiently high cross-
sectional
area
to
deterioration.
The recommended cross-section area is six square
2
millimetres (6.00mm
).
If it is delivered without
has
occurred,
prevent
overheating
This is a type 'X' appliance, which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may also be fitted in a corner setting.
Side walls which are above hob level should be
protected by heat resistant non-combustible material
and MUST NOT be nearer than 40mm to the hob
side.
A nominal air gap of 10mm at the sides of the
appliance is required to enable the appliance to be
the
moved into position.
Overhanging surfaces or a cooker hood should be a
minimum of 685mm above the hob.
and
To move the appliance, open the main oven door,
and lift the appliance by holding inside the top of the
oven compartment.
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents