Table of Contents
Advertisement
INTRODUCTION
WARNING: THIS APPLIANCE MUST BE EARTHED
RATING PLATE
This is situated on the lower front frame of the
appliance and can be seen upon opening the door.
Alternatively the rating plate may also be found on
the back or top of some models (where applicable).
The appliance must be protected by a suitably
rated fuse or circuit breaker.
appliance is given on the rating plate.
Do not remove the rating plate from the
appliance as this may invalidate the guarantee.
INSTALLATION
If your appliance has been damaged in transit,
contact your supplier immediately.
attempt to install it.
Your appliance left the factory fully packaged to
protect it from damage. If it is delivered without
packaging
and
damage
manufacturer cannot accept responsibility. Contact
your supplier for advice.
Once the packaging has been removed the
appliance should only be moved by hand.
NOT use a sack barrow or any other aid to lift the
appliance as damage may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation in all poles.
cable must have conductors of sufficiently high
cross-sectional area to prevent overheating and
deterioration.
The recommended cross-section area is six square
2
millimetres (6.00mm
).
For SB432BTS
The electrical connection must be made using an
all pole isolating switch, or other suitable means of
disconnection,
with
separation. The cable must have conductors of
sufficiently high cross-sectional area to prevent
overheating and comply with all relevant wiring
regulations.
The recommended cross-section area is six square
2
millimetres (6.00mm
).
The rating of the
DO NOT
has
occurred,
at
least
3mm
contact
The cable should be routed away from potentially
hot areas marked by X in the diagram below.
To move the appliance, open the main oven door,
and lift the appliance by holding inside the top of
the oven compartment.
the
DO
This is a type Y appliance, which means it is free-
standing and can be fitted with cabinets on one or
both sides. It may also be fitted in a corner setting.
A nominal air gap of 2mm at the sides of the
appliance is required to enable the appliance to be
moved into position.
The
Side walls which are above hob level should be
protected
material and MUST NOT be nearer than 40mm to
the hob side.
Overhanging surfaces or a cooker hood should be
a minimum of 685mm above the hob.
It is important to ensure that the appliance is level
after installation.
appliance to accommodate uneven floors.
8
by
heat
resistant
Levelling feet are fitted to the
non-combustible
Advertisement
Table of Contents
