Crankshaft Angle (Ns) Sensor - Honda Goldwing GL1200L 1985 Manual

Crankshaft Angle (Ns) Sensor - -.........- - - - -...........................- - - - -
Measure sensor coil resistance between the No. 6 and
No. 25 ECU terminals. Resistance should be
297· 363 ohms at 20" C If resistance is incor-
rect, check the sensor
Check for between the sensor
harness side terminal and the ECU The sensor is
normal if there is between the NO.6 ECU ter-
minal and the sensor harness Y the No. 25 ECU
terminal and the sensor harness W terminal.
With the sensor check for
"nrUlnll JlTV
ween the No.6 and No. 25 ECU terminal and
other terminals.
Check the sensor f'",,,,I,~r for poor contact at the ter-
minals.
Reisis'tanlce Inspection
Remove the call from the frame page
Remove the Ns sensor white 2P from the holder.
Measure the resistance between the and white
vV'UI.J"1;;'1
terminals.
Resistance: 291-363 ohms
Check for no
{,"f,tir",
Iit\l
between each of the two ter-
minals and Install a new Ns sensor if the
resistance is out of sPElcificaltion
Inspection
belt covers.
the rotor projection with
and left front
Inspel::t the air gap when the sensor is or
belt drive is removed.
Air gap: 0.4-0.9 mm
Measure the air gap.
Rotate the crankshaft
the sensor.
Remove the
Remove the radiator,
10. . . 27