Camshaft Angle (Gr, Gl) Sensors10·28 - Honda Goldwing GL1200L 1985 Manual

eFt System
.
Camshaft Angle
(GR, Gl)
S e n s o r s - - - - - - - - - - - - - -
LED Inspection
feu
COUPLER
measure the Disconnect the sensor
resistance of the sensor coil
If the GR sensor is measure the resistance bet·
ween the No.8 and No. 24 ECU terminals. If the
GL sensor is measure the resistance between the
No.7
and
No.
24
coupler terminals.
Resistance
should be 140·180 ohms at 20
<>
C
Check for between the harness side sensor
",.",nl••r
terminals and the ECU terminals. The sensor
is
normal if there is between the Y/W sensor ter-
minal and the No. 7 ECU the Bu/W and
the No. 8 and each of the and blue ter·
minals and the No. 24 terminal.
With the sensor coupler check for no can-
between the No. 7 and No. 8 ECU ter·
minals and ground or other terminals.
Check the sensor
I,;VUl.lt,;:"
minals.
for poor contact at the ter·
Coil Resistance Inspection
Remove the fairing.
Remove the GR/GL white 4P sensor from the
holder. Measure the GL sensor coil resistance between
the W with Y tube and Y terminal.
Measure the NR sensor coil between the G
with Bu and W tubes and Bu terminal.
Re~liiti~nce:
140-180 ohms <at 20° 68° F)
Check for no between each terminal and
Install a new sensor if there is
Air Gap Inspection
NOTE: Check the air gap when the sensor is removed or
Remove the sensor cover. Rotate the crankshaft and
the rotor With the sensor.
Measure the air gaps,
Air gap: 0.58-0.62 mm (0.023-0.024 In)
10..28