One-Way Valve - Honda Goldwing GL1200L 1985 Manual

One-Way Valve - - - - - - - - - - - - - - - - - - - - -
Pressure should not remain.
Pressure should remain
Disconnect the vacuum hose from the intake of the
Connect
a
hand air pump to the vacuum
air pressure.
Disconnect the vacuum hose from the accumulator. Con-
nect
a
hand air pump to the vacuum hose and air
pressure,
If unable to obtain the above
I
""",un. . "
install
a
new ona-
way valve.
NOTES:
HOLD: Vacuum should remain steady when battery voltage is applied
to the terminals
RELIEVE: Vacuum should be relieved when battery is applied.
DECREASE: About 100·150 of vacuum will be each time
battery voltaae is a ,plied.
Battery Voltage Vacuum
( .} batlery wire
I( .)
battery wire Blocked lube
Blocked tube
connected
not connected
(Port closed) (Port open)
Current not applied
HOLD HOLD
BriBI BrlW RELIEVE
RELIEVE
G BrlW HOLD
HOLD
Sr Br/W HOLD
HOLD
Br/BI, G Br/W
RELIEVE RELIEVE
BriBI, Sr Br/W
RELIEVE RELIEVE
Sr, G Br/W
HOLD HOLD
8ri81, Sr, G Br/W
DECREASE RELIEVE
Control VaIve
If unable to obtain sp'::lci1ied
''''~'U'''''.
install a new valve.
While malint:alninq vacuum,
the terminals shown
in
the table on the
Test each of terminals with the actuator hose
open and then blocked with
a
hose.
Avoid toulching the (
+)
test
wire to the ( - ) test wire. If a test involves two
or more first connect all negative
wires to the battery then connect the
Dositive wire to the
wire.
Connect
a
vacuum pump to the intake vacuum hose
and vacuum. If the vacuum does not remain
install
a
new valve.
Remove the cruise control valve from its bracket Discon-
nect the valve off the intake and ac-
tuator vacuum hoses with
a
small screwdriver.
CAUTION: The plalstic connectors are Pull the
hoses side stress may break the connec-
tors.
13-15