ZyXEL Communications P-334WT Support Notes page 53

You must first install TCP/IP software on each PC before you can use it for Internet access. If you have already installed TCP/IP,
go to the next section to configure it; otherwise, follow these steps to install:
In the Control Panel/Network
In the Select Network Component Type
In the Select Network Protocol
Protocols and click OK.
3. TCP/IP Configuration
Follow these steps to configure Windows TCP/IP:
In the Control Panel/Network
In the TCP/IP Properties window, select
Note: Do not assign arbitrary IP address and subnet mask to your PCs, otherwise, you will not be able to access the Internet.
Click the WINS configuration tab and select
Click the Gateway
Click the DNS Configuration
Click OK to save and close the
Click OK to close the Network window. You will be prompted to insert your Windows CD or disk. When the drivers are
updated, you will be asked if you want to restart the PC. Make sure your Prestige is powered on before answering Yes to the
prompt. Repeat the above steps for each Windows PC on your network.
Setting up the Prestige router
The following procedure is for the most typical usage of the Prestige where you have a single-user account (SUA). The Prestige
supports embedded web server that allows you to use Web browser to configure it. Before configuring the router using Browser
please be sure there is no Telnet or Console login.
1. Retrieve Prestige Web
Please enter the LAN IP address of the Prestige router in the URL location to retrieve the web screen from the Prestige. The default
LAN IP of the Prestige is 192.168.1.1. See the example below.
2. Login first
To restrict only the adminstrator can configure the router, there is a login procedure prompted for asking User Name and Password.
The default User Name is 'admin' and the default password is the default SMT password, '1234'.
3. Configure Prestige for Internet access by using WIZARD SETUP. The Web screen shown below takes PPPoE as the example.
window, click
windows, select
windows, select
window, click the
Obtain an IP address
tab. Highlight any installed gateways and click the
tab and select
TCP/IP properties window
Add button.
Protocol and click Add.
Microsoft from the manufacturers, then select
TCP/IP entry to select it and click
automatically.
Disable WINS Resolution.
Disable DNS.
Properties
Remove button until there are none listed.
TCP/IP from the Network
button.