System Setup
Connecting and
Disconnecting the
F300-FS Strobe I/F Unit
1, 2, 3...
RS-232C I/F Unit
Use the following procedure to connect or disconnect the F300-FS Strobe I/F
Unit and strobes.
1. Hold the rubber-molded part of the connector, align the notches, and push
the connector straight in until it locks.
2. Lightly pull the lock ring to unlock the connector and pull the connector
straight out. Do not apply undue force to the rubber molding or the cable.
F300-E2 RS-232C I/F Unit
Channel 0
RS-232C Cable
Note
After inserting the connector, tighten the upper and lower screws.
⇒
The user must prepare a cable. Refer to 2-2-5 F300-E2
RS-232C I/F Unit for cable connections in detail.
Section
Personal computer
3-5
59