Control Panel Assembly (Service-Only Procedure); Removing The Control Panel Assembly - Dell PowerVault 500 Owner's Manual

Hide thumbs Also See for PowerVault 500:
Table of Contents

Advertisement

NOTE:
Reinstall the hard drives in the same drive bays from which they were removed.
 
10. If applicable, reconnect the internal tape drive. See
 
11. If applicable, reconnect the diskette drive. See
 
12. If applicable, reconnect the optical drive. See
 
13. Close the system. See
Closing the
 Control Panel Assembly (Service-only Procedure)
NOTE:
The control panel assembly consists of two separate modules—the display module and the control panel circuit board. Use the following
instructions to remove and install either module.
 

Removing the Control Panel Assembly

 
CAUTION:
Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
 
1. If applicable, remove the bezel. See
 
2. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet and peripherals.
 
3. Open the system. See
Opening the
 
4. Disconnect the control panel cable at back of the control panel board. See Figure 3-34.
NOTICE:
Do not pull on the cable to unseat the connector. Doing so can damage the cable.
a.  Squeeze the metal tabs on the ends of the cable connector.
b.  Gently work the connector out of the socket.
 
e. Disconnect the display module cable from the control panel board. See Figure 3-34.
 
f. Remove the three screws that secure the control panel board to the system chassis and remove the board. See Figure 3-34.
 
g. Remove the display module:
a.  Insert the end of paper clip into the hole on the right side of the display module and gently pry off the label.
b.  Using a T10 Torx driver, remove the two screws that secure the display module to the system chassis.
c.  Remove the display module from the chassis cutout.
 Figure 3-34. Control Panel Removal
Removing and Installing an Internal SCSI Tape
Installing the Diskette Drive Into the
Installing the Optical
Drive.
System.
Removing the Front
Bezel.
System.
Drive.
System.

Advertisement

Table of Contents
loading

Table of Contents