Installing The Cooling Shroud; Removing The Fan Bracket - Dell PowerVault 500 Owner's Manual

1 shroud pivots (2)
3 release latch
5 fan bracket

Installing the Cooling Shroud

1. Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3-10.
2. Slowly lower the shroud straight down into the system until the fan connector engages and the latches snap into place.
Fan Brackets

Removing the Fan Bracket

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the
3. Remove the cooling shroud. See
4. Remove the SAS controller daughter card. See
5. Remove the fans from the fan bracket. See
6. Remove the fan bracket from the system:
a. Press down on the release latch on the left side of the fan bracket. See Figure 3-11.
If the bracket does not disengage completely, push down slightly on the bracket when releasing the latch.
b. Rotate the left side of the bracket upward, releasing the plastic clip from its slot in the power supply cage.
c. Draw the bracket out of the system.
Figure 3-11. Removing and Installing the Fan Bracket
2 cooling shroud
4 shroud hinges (2)
System.
Removing the Cooling Shroud.
Removing a SAS Controller Daughter Card
Removing a System Fan.