Removing Memory Modules - Dell PowerVault 500 Owner's Manual

1 memory module 2
3 socket 4
6. Align the memory module's edge connector with the alignment key on the memory module socket, and insert the memory module in the socket.
NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way.
7. Press down on the memory module with your thumbs while pulling up on the ejectors with your index fingers to lock the memory module into the socket.
When the memory module is properly seated in the socket, the ejectors on the memory module socket align with the ejectors on the other sockets that
have memory modules installed.
8. Repeat step 3 through step 7
9. Replace the memory cooling shroud. See
NOTICE: Never operate your system with the memory cooling shroud removed. Overheating of the system can develop quickly resulting in a shutdown
of the system and the loss of data.
10. Close the system. See Opening the
11. (Optional) Enter the System Setup program, and check the System Memory setting on the main System Setup screen. See
Program.
The system should have already changed the value to reflect the newly installed memory.
12. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat
ensure that the memory modules are firmly seated in their sockets.
13. Run the system memory test in the system diagnostics. See

Removing Memory Modules

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See
your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against
electrostatic discharge.
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2. Open the system. See Opening the
3. Remove the memory cooling shroud. See
NOTICE: Never remove the memory cooling shroud without first powering down the system. Overheating of the system can develop quickly resulting in
a shutdown of the system and the loss of data.
4. Locate the memory module sockets on the system board. See Figure 6-2.
CAUTION: The DIMMs are hot to the touch for some time after the system has been powered down. Allow the DIMMs to cool before handling
them. Handle the DIMMs by the card edges, and avoid touching the DIMM components.
memory module socket ejectors (2)
alignment key
of this procedure to install the remaining memory modules.
Installing the Cooling Shroud.
System.
Running the System
System.
Removing the Cooling Shroud.
step 2 through step 11
Diagnostics.
Entering the System Setup
of this procedure, checking to