Electrical Connection - Calcana CAL Series Installation, Operation, Service, And Parts Manual

CAL-SERIES
20.0

ELECTRICAL CONNECTION

Refer to rating plate on heater for electrical specifications. All electrical connections must be made by a
qualified/licensed experienced electrician.
Supply grounded, adequate electricity to the three prong electrical cord attached to the burner head.
WARNING:
DO NOT operate heater until it has been thoroughly installed, inspected and is ready
for initial fire-up.
NOTE: All electrical connections and wiring must be made in accordance as follows:
CANADA: Canadian Electrical Code, CSA C22.1 or latest edition.
USA: National Electrical Code, ANSI/NFPA 70 or latest edition
In Canada: Electrical equipment and wiring shall comply with the applicable provisions of the current
Canadian Electrical Code, CAN/CSA C22.1, Part I and Part II, and CAN/CSA C22.2 No.3, Electrical features
of Fuel Burning Equipment.
If any of the original wire as supplied with the appliance must be replaced, it must be replaced with wiring
material having a temperature rating of at least 105 degrees C (221 °F).
This heater is equipped with a three-prong (grounding) plug for your protection against shock hazard and
should be plugged directly into a property grounded three-prong receptacle. Do not cut or remove the
grounding prong from this plug.
49