Tilt Installation; 25° Tilt (All Lengths); Figure 21. 25° Tilt - Calcana CAL Series Installation, Operation, Service, And Parts Manual

CAL-SERIES

10.2 TILT INSTALLATION

Refer to Figure 21 & Figure 22, for 25° to 45° tilts. Locate suspension points as described above under
the title "HORIZONTAL INSTALLATION". It is important NOT to over-tilt the heater. Units are certified for
installation up 45°; however, the MAXIMUM recommend tilt is no greater than 25°.
WARNING:
It is the responsibility of the installer to use hanging chain that is a minimum of
2/0 or with a minimum support capacity of no less than 75 lbs. Also make sure all suspension
points are adequate to support weight of heater and any accessories. Also make sure all S-
Hooks are affixed properly and the open ends squeezed closed. If the suspension system fails,
it is the responsibility of the installer. A failed suspension system can cause property damage,
severe injury and/or death.
Refer to page 27 "ASSEMBLY OF COMPONENTS" to page 31 "ASSEMBLY OVERVIEW".
25° TILT (ALL LENGTHS)
NOTE: 25° Tilt is maximum recommended tilt for most installations.
Figure 21. 25° TILT
25