CAL-SERIES
15.0
OUTDOOR APPLICATIONS
Units can be installed in outdoor locations.
Procedure:
•
Attach Outdoor Air Intake Hood to air intake collar located on end of burner box with three (3) screws.
Apply silicone adhesive to seal joint.
•
Attach vent cap to exhaust end of heater with two (2) screws. Trim excess length from vent cap prior
to installing into adaptor.
•
FUEL SUPPLY: Via approved flexible connector for your area. (see page 47)
CANADA: Natural Gas and Propane Installation Code, CSA B149.1 or latest edition.
USA: National Fuel Gas Code, ANSI Z223.1/NFPA 54, or latest edition.
•
Electrical connections for outdoor locations must be made in accordance with:
ELECTRICAL GROUNDING:
CANADA: Canadian Electrical Code, CSA C22.1 or latest edition.
USA: National Electrical Code, AN51/NFPA 70 or latest edition
In Canada: Electrical equipment and wiring shall comply with the applicable provisions of the current
Canadian Electrical Code, CAN/CSA C22.1, Part I and Part II, and CAN/CSA C22.2 No. 3, Electrical
features 0/ Fuel Burning Equipment.
OUTDOOR INSTALLATIONS
Figure 35. OUTDOOR INSTALLATIONS
43