Dimensions; Figure 1. Equipment Dimension - Calcana CAL Series Installation, Operation, Service, And Parts Manual

CAL-SERIES
STANDARD EQUIPMENT:
Burner control housing is pre-assembled and pre-wired; unit comes complete with the following: industry
standard gas, electrical and venting connections, balanced air rotor, thermal overload protected motor, visual
burner inspection sight glass, combustion and air proving safety switches, 3-try spark ignition control, low
voltage thermostat connection, 4" aluminized steel combustion tube, polished aluminum standard reflector,
4" aluminized steel radiant heat exchanger, tube couplers, joint/hanger pieces, heat economizer baffle,
low/line voltage thermostat, and hanging chain kit.
Optional Equipment:
- 90° Elbow Kit
- Variable Input Control (Modulator)
- Stainless Steel Construction
- 24 Volt input
5.0

DIMENSIONS

15"
(38.1 cm)
- Hi/Lo Control
- Two Piece Construction
- 180° U-Bend Kit
- Fresh Air Kit
BURNER END
"A" (SEE TABLE BELOW FOR DIMENSIONS)
SIDE VIEW

Figure 1. EQUIPMENT DIMENSION

7
- Sidewall Vent Kit
- Protective Screen
- Three Piece Construction
- Four Piece Construction
EXHAUST END