Making Connections And Rear Panel Settings - Extron electronics CrossPoint 450 Plus Series Setup Manual

Making connections and rear panel settings

WARNING: Turn the input and output devices off and
unplug their power cords.
AVERTISSEMENT:
sortie puis retirer les câbles d'alimentation.
NOTE: Video connectors are grouped by video
plane. Connect the input or output on each video
plane to the corresponding connector in the
correct group. Refer to the CrossPoint 450 Plus /
CrossPoint Ultra / MAV Plus Switcher Manual to
connect the various video formats to and from the
various models if you are not sure.
a
Video inputs — Connect RGBHV, RGBS, RGsB,
RsGsBs, component/HDTV video, S-video, or
composite video sources, as appropriate to the video
format and matrix size or your switcher model.
b
Video outputs — Connect RGBHV, RGBS, RGsB,
RsGsBs, component/HDTV video, S-video, or
composite video displays, as appropriate to the
video format and matrix size of your switcher
model's.
c
Sync termination switches (CrossPoint switchers) — Set
the switches as necessary to condition non-TTL sync levels
greater than 5 Vp-p. Sync termination enables the sync to be
properly passed from input to all selected outputs.
NOTES:
•
CrossPoint 450 Plus switchers have Sync
termination switches for inputs 1 through 8.
• CrossPoint Ultra switchers have Sync termination
switches for inputs 1 through 4.
•
The matrix switchers have two sets of sync
termination switches; one for horizontal or
combined sync and a second set for vertical sync.
510 ohms — The default position, suitable for most video.
75 ohms — Typically required only for an input with non-TTL
sync (greater than 5 V p-p).
NOTE:
a display that is rolling vertically and/or tearing
horizontally, could indicate a non-TTL sync input. If you
are not sure, check the specifications in the user manual
for the input device.
Éteindre tous les appareils d'entrée et de
An input that produces an out of sync display,
CrossPoint / MAV Matrix Switchers • Installation
1
2
1
2
1
2
1
2
1
2
5