Table of Contents
Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
The 1/3 platform lift is designed to be used only with a Workman Vehicle and must be mounted with the wire
harness, level, decals, switches, and all interlock switches installed. The 1/3 platform lift will only work on
Workman 3000 and Workman 4000 Series machines with serial numbers 240000001 and up and all Workman
HD, HDX, HDX-D, and HDX-Auto vehicles.
Description
No parts required
No parts required
No parts required
Main wire harness with relays
Cable tie
Screw (1/4 x 3/4 inch)
Nut (1/4 inch)
Fuse
Mini fuse (Workman HDX-Auto only)
Parking brake switch
Hex-head screw (3/8 inch)
Wire harness—3 ft extension (HDX-Auto
only)
Bracket (HDX-Auto only)
Bolt—1/4-20 (HDX-Auto only)
Plate (HDX-Auto only)
Locknut (HDX-Auto only)
Flat washer (HDX-Auto only)
Rear level switch bracket
Rear level switch with the harness
Washer
No parts required
Reinforcing plate
Flange HD capscrew (3/8 x 1 inch)
Flange nut (3/8 inch)
Battery cable with boot
Negative battery cable
Bubble level indicator
Operation decal
No-step decal
Qty.
–
Prepare to install the kit.
Remove the center console, seat
–
shroud, and seat assemblies.
Remove the CVT cooling duct
–
(HDX-Auto only).
1
7
2
Install the main wire harness and relays.
2
1
1
1
2
1
1
Mount the parking brake switch.
1
1
1
3
1
1
Mount the rear level switch.
2
Install the hood, ROPS shield shroud,
seats, seat shroud, console cover
–
plates, and CVT intake hose (HDX-Auto
only).
2
4
Mount the lift onto the machine frame.
4
1
Connect the wire harness and battery.
1
1
Mount the bubble level indicator.
1
Install the decals.
2
6
Use
Advertisement
Table of Contents
