Table of Contents
Advertisement
Mounting the Parking Brake
Switch Workman Models with a
Manual Transmission
1.
Mount the parking brake switch to the parking
brake mount with 2 screws as shown in
11.
1. Switch
2.
Plug the switch wire connector into the lift wire
connector harness.
3.
Remove the loop back connector from the
machine wire harness labeled 1/3 lift.
4.
Connect the lift wire harness to the machine
wire harness.
6
Mounting the Rear Level
Switch
Parts needed for this procedure:
1
Rear level switch bracket
1
Rear level switch with the harness
2
Washer
For Workman 3000 and Workman
4000 Series machines with Serial
Numbers 240000001 and Up
1.
Remove the locknuts securing the top of the
hitch plate to the rear axle
Figure 11
(Figure
12).
Figure
1. Hitch plate
g007162
2.
Using the upper set of mounting holes, mount
the level switch bracket to the rear axle with the
locknuts previously removed.
3.
Route the switch harness forward, along the
differential lock cable to the left side of the
machine.
Note:
hot (exhaust) or moving parts.
4.
Secure the harness to the differential lock cable
with cable ties.
For Workman HD, HDX, HDX-D,
and HDX-Auto machines
1.
Remove the capscrews securing the hitch plate
to the rear axle
1. Hitch plate
2.
Using the lower set of mounting holes, loosely
mount the 2 washers, and level the switch
12
Figure 12
2. Level switch bracket
The harness must not interfere with any
(Figure
13).
Figure 13
2. Level switch bracket
g016822
g016821
Advertisement
Table of Contents
