Preparing To Install The Kit; Removing The Center Console, Seat Shroud, And Seat Assemblies - Toro Workman 07347 Operator's Manual

1

Preparing to Install the Kit

No Parts Required
For Workman 3000 and Workman
4000 Series machines with Serial
Numbers 240000001 and Up
1. Position the machine on a clean, level surface,
shut off the engine, engage the parking brake,
and remove the key from the ignition switch.
2. Disconnect the positive cable from the battery.
3. Remove the 6 screws and nuts securing the
bumper to the machine frame and remove the
bumper.
4. Remove the 7 screws securing the front hood to
the machine frame and remove the hood.
For Workman HD, HDX, HDX-D,
and HDX-Auto machines
1. Position the machine on a clean, level surface,
shut off the engine, engage the parking brake,
and remove the key from the ignition switch.
2. Disconnect the positive cable from the battery.
3. Raise or remove the bed from the machine if
equipped.
Note:
Refer to the machine Operator's Manual
for more detailed information on raising and
removing the bed.
4. Remove the hood.
Note:
Refer to the machine Operator's Manual
for more detailed information on removing the
hood.
2
Removing the Center
Console, Seat Shroud, and
Seat Assemblies
No Parts Required
Removing the Center Console for
Workman 3000, 4000, HD, HDX,
and HDX-D Machines
CAUTION
Pressurized hot coolant escaping can cause
serious burns.
Allow the engine to cool enough to touch
before the removing overflow tube or radiator
cap.
1. Unscrew and remove all knobs from the control
levers and from the gear shift lever
1. Gear shift lever
2. Jam nut
3. Shifter handle
2. Remove the jam nut from the gear shift lever
(Figure 2).
3. Remove the 6 screws securing the outside edge
of the cover plate of the center console to the
chassis and remove the cover plate
7
(Figure
Figure 2
4. Control lever
5. Control knob
(Figure
2).
g023161
3).