Chapter 5: Installing The Ers 3500 Series; Installation Checklist - Extreme Networks Extreme Switching 3500 Series Installation Manual

Chapter 5: Installing the ERS 3500 Series

This chapter provides the information and procedures to install the ERS 3500 Series.

Installation checklist

Use this checklist to install the ERS 3500 Series.
Table 1: Installation checklist
No. Task
1. Install the switch.
Installation depends on the switch
model. ERS 3510T or ERS 3510GT-
PWR+ can be mounted on a wall,
table, or shelf. Optionally, it can also
be mounted in an equipment rack.
All the other switches in the ERS
3500 Series are installed in an
equipment rack.
2. Connect the AC power cord to the
switch.
3. Check LEDs to verify the installation. See,
4. (Optional) Connect the switches in a
stack.
December 2017
Description
Do any one of the following:
• Installing ERS 3500 in an equipment
rack on page 22
• Installing ERS 3510GT or ERS
3510GT PWR+ on a table or shelf
page 25
• Installing a single ERS 3510GT or
ERS 3510GT-PWR+ switch in an
equipment rack
• Installing two ERS 3510GT or ERS
3510GT-PWR+ switches in an
equipment rack
See, Connecting the AC power cord to
the switch
LED state definitions
See, Connecting the switches in a
stack on page 37.
Installing Ethernet Routing Switch 3500 Series
on page 26
on page 28
on page 41.
on page 45.
on
15