Extreme Networks Extreme Switching 3500 Series Installation Manual page 31

5. Perform one of the following:
• To connect two ERS 3510GT or two 3510GT-PWR+ switches together use the rear
bracket as shown below, with four M4 pan head screws to secure the switches at the rear.
Once the rear bracket has been installed, the switches can be installed in the rack.
• To connect one ERS 3510GT switch and one ERS 3510GT-PWR+ switch together
use the offset rear bracket with four M4 pan head screws to join the switches at the rear.
Once the rear bracket has been installed, the switches can be installed in the rack.
Note:
If you are mounting a mix of ERS 3510GT and ERS 3510GT-PWR+ units side by
side, ensure that the ERS 3510GT unit is mounted on the LEFT side (when viewed
from the front) for adequate airflow.
6. Slide the switches into the rack. Insert and tighten the rack mount screws.
7. Verify that the switch is securely fastened to the rack.
December 2017 Installing Ethernet Routing Switch 3500 Series
Switch installation
31